ESAB POWERCUT-1500 Instruction Manual download pdf (Page 11)

SECTION 2 INSTALLATION

2.1 GENERAL

Proper installation is important for satisfactory and trouble-free operation of

the PowerCut 1500 cutting package. It is suggested that each step in this

section be studied carefully and followed closely.

2.2 EQUIPMENT REQUIRED

A source of clean, dry air that supplies 165 l/m (350 cfh) at 5.5 bar (80 psig)

is required for the cutting operation. The air supply should not exceed 10.3

bar (150 psig) (the maximum inlet pressure rating of the air filter-regulator

supplied with the package).

2.3 LOCATION

Adequate ventilation is necessary to provide proper cooling of the PowerCut

1500. The amount of dirt, dust, and excessive heat to which the equipment

is exposed, should be minimized. There should be at least one foot of

clearance between the PowerCut 1500 power source and wall or any other

obstruction to allow freedom of air movement through the power source.

2.4 INSPECTION

A. Remove the shipping container and all packing material and inspect for

evidence of concealed damage which may not have been apparent

upon receipt of the PowerCut 1500. Notify the carrier of any defects or

damage at once.

B. Check container for any loose parts prior to disposing of shipping

materials.

C. Check air louvers and any other openings to ensure that any obstruction

is removed.

2.5 PRIMARY ELECTRICAL INPUT

CONNECTIONS

The PowerCut 1500 consoles are equipped with approximately 3.1m (10 ft.)

of 4-conductor input power cable for 3-phase connection.

Installing or placing any type of

filtering device will restrict the

volume of intake air, thereby

subjecting the power source

internal components to over-

heating. The warranty is void if

any type of filter device is used.

ELECTRIC SHOCK CAN KILL!

Precautionary measures

should be taken to provide

maximum protection against

electrical shock. Be sure that

all power is off by opening the

line (wall) disconnect switch

and by unplugging the power

cord to the unit when connec-

tions are made inside of the

power source.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Comments to this Manuals

No comments

ESAB POWERCUT-1500 Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Power universal cutters ESAB POWERCUT-1500