ESAB POWERCUT-1250 Instruction Manual download pdf (Page 11)

SECTION 3 INSTALLATION

3.1 FITTING THE PT-32EH TORCH

1. For operator safety, the torch connections are

located on the output terminal board behind the

lower portion of the front panel.

2. Thread the power cable, pilot arc cable and switch

leads of the PT-32EH through the Strain Relief on

the Access Cover.

4. Connect power cable to the torch fitting (left-hand

threads) and tighten securely.

5. Connect the Pilot Arc Leads. Make sure the power

cable connection is wrench-tight.

6. Plug in the switch leads to the torch switch recep-

tacle on the output terminal board.

7. Reassemble the access door to the power source.

Retighten Strain Relief to secure power cable, but

do not overtighten.

POWER CABLE

PILOT ARC LEAD

(2) WHITE LEADS

POWER

CABLE

CONNECTION

PILOT ARC

CONNECTION

TORCH TRIGGER

LEADS CONNECTION

Figure 3-1. Typical Connection Assembly

FOR COMPLETE SAFETY AND INSTALLATION

PROCEDUREES, CONSULT THE INSTRUCTION LIT-

ERATURE SPECIFIC TO THE CONSOLE BEING

USED.

NOTE:

This Illustration depicts connections for

Powercut 1250 and 1500. Other Powercut

models; i.e., 875 and 1125 have identical

fittings but the connection points are

configured in different locations on the front

panel. Consult the specific console literature

for complete information.

Before any maintenance is attempted on this torch,

make sure the power switch on the console is in the

"OFF" position and the primary input is deenergized.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments

ESAB POWERCUT-1250 Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Measuring, testing & control ESAB POWERCUT-1250